Everyone may know about the use of bus machine, but there is another problem that needs to be solved by ourselves. At this time, although the manufacturer will give some suggestions, it still checks by itself, that is, the acceptance test of bus machine.
Let's take a look at the acceptance test of bus generator:
1. Idling operation: operate for about 30 minutes under no-load condition, check whether there is obvious temperature rise at each bearing and sliding part, and whether the high and low speed of the test equipment and the execution of various actions are good during idling operation.
Check the position accuracy when parking across the slot, and check whether the brake is effective, and whether the tensioner and threading wheel in the threading device are smooth and smooth.
2. Visual inspection and measurement: during the unpacking and assembly of the equipment, you can observe whether the appearance and various configurations of the equipment are complete, and check the contact and smoothness of various sliding parts during the assembly process.
Use testing tools to measure the coaxiality of various shafts and sleeve holes, and check the lubrication of relevant action parts, which shall be stable, reliable and free of blockage.
3. After idling operation, the bus machine needs to run with wire. In the process of winding, check whether the number of winding coils is counted accurately, whether the movement of wire arrangement device is smooth and correct, and visually check whether the wound coil is flat and compact and whether the insulation layer of enamelled wire is good according to the set process.
For the acceptance and inspection of bus machine, never judge according to your own experience, so the detailed problems existing in the equipment can not be found. If you want to carry out the acceptance and inspection of bus machine, you can do it according to the above steps.
The above is the acceptance test method of bus machine. If you need anything, you can contact us!
